![]() |
Quote:
|
Quote:
|
Quote:
I will. I'm not NA though. I'll have the AAM twin turbo on my car. I'm not certain what I'll be tuning with. Possibly Uprev for a while, then ECUTek. If Uprev steps up with some more features I'll likely keep it. We will see. |
My dyno/tuning results
1 Attachment(s)
Ok gents, as promised, here are my results after getting a retune from Seb today. They are not back-to-back pre equipment/post equipment so take that as it is. Ill try and answer any questions I can for you.
Top graph is with EPS thottles and +20 degrees air temp from bottom graph Bottome graph is from original tune about a year ago Showing +4-5whp with 20 deg air temp increase Over all I am very pleased with this purchase. Its not just the 5-10whp up top, its the more tq better response feeling down low and mid. I would not hesitate to recomend this mod to anyone that wants to spend the money. Just know that youll need a retune. |
Quote:
Jake EPS Tuning |
Quote:
|
Which intake do you have and do you also have ported upper and lower manifolds?
Quote:
|
Quote:
|
I'm pretty sure I've answered this (not sure if it was to you or not but...). The best way to go about an upper/lower IM, is to get with either Synolimit or Synergy and have them port & port-match the components. For example [on my car], I had the manifolds (upper outlet/lower inlet) port-matched to each other. Afterwards, he ported the upper manifold inlet where it meets the TB outlet as much as he could without ruining where the gasket seals... from there, he port-matched outlet of the billet adapter that comes with the EPS TBs to the inlet of the upper manifold (and he double-checked that the outlet of the TBs were matched to the inlet of the billet adapter).
I'd say for an N/A car, this would be the best setup. You "should" be able to substitute the Motordyne/Z1 manifolds and have the same done to them, although I'm not sure how the Z1 is ported but I know the Motordyne is not. The results may change, or may be the same. The AAM manifold hasn't been shown to make or lose power (or do anything as far as anyone can tell), and neither has the RJ Mfg GTR conversion so your best guess is as good as anyone's for aftermarket manifolds. |
1 Attachment(s)
Just got these installed. Was a very humid day but they baselined the car before adding the throttle bodies so you can see the improvement.
Dyno was on a Mustang Dyno. Installed mods on car: Injen Air Intakes Upper/Lower ported intakes by Z1 FI Long Tube Headers Magnaflow Exhaust Attachment 122661 |
Nice pick up, and the curves look good. :tup:
|
I wonder how these compare with Synolimit's TBs?
Sent from my SM-G930V using Tapatalk |
Quote:
|
Quote:
What kinds of gains did you see? Hard for me to justify 2000 plus unless the gains are major. Sent from my iPhone using Tapatalk |
Quote:
Sent from my SM-G930V using Tapatalk |
All times are GMT -5. The time now is 04:06 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2