Ram Air
Has anyone tried the ram air, by removing the fang plates(pros -cons)
|
Ram air for what? You can remove the fang plates but then you need to direct the air somewhere for it to do anything.
|
There is a mod for that on this forum.
|
Its gotta make some difference if done right. I think the intakes would have to be insulated from the engine heat to tho. I think itll work only because it would lower intake temps but i can see it being too signifgant as in power wise. i COULD BE WRONG THO
|
this has been brought up before. i think someone was testing the gen 3 stillen with and without a front bumper. they had fans blowing on the filters in one test. the outcome wasnt a huge increase in power. actually i think there were issues with turbulence.
our factory intake system isnt that bad to begin with. |
Quote:
|
lemers do you know where I could find that forum
|
Diy
|
|
|
Quote:
|
your better off making duct work for the brakes. there is very lil to gain by home depot-ing your front end.... :\
|
Quote:
DIY Front Lip... - Club RSX Message Board |
Quote:
|
Didn't think ram air was good enough for my Mustang, definitely won't do it to my Z. Save your $ for some real intakes. The cost for MAF tubes and drop ins will probably be marginally more than a ram air diy.
|
All times are GMT -5. The time now is 05:33 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2