SAM@GTM |
02-19-2012 03:20 PM |
Quote:
Originally Posted by Nissan370
(Post 1550322)
any high hp guys max the maf out yet on our cars
just tring to get an idea at what hp lvl's we need new maf sensors.
thxs
|
Two main factors, Maf location and pipe diameter, With our blow through set up and our 3" piping you will be at 4.8 to 4.9 volts in the 600 WHP mark. this have been very consistent due to our Maf locations.
Now if you have the stillen draw through set up then your mafs will max out much sooner, I have seen them max out at low 400WHP .
Quote:
Originally Posted by Vince@R/T
(Post 1553089)
|
No They are not the GT mafs's Calibration from UPREV, as i have said that before in that same thread. Our calibration has much bigger sealing.
Quote:
Originally Posted by SAM@GTM
(Post 1357550)
There is one source for those after market maf sensors, These are the same sensors that UPrev, AAM, AMS uses, We are just applying our own Calibration on them .
Sam
|
|