|
I also had this problem recently...it happened to be my pins on MAF1 going to Bank 1, right at the end of the pig tail. Apparently when using the Stillen
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
01-09-2018, 08:29 AM
|
#16 (permalink) |
|
A True Z Fanatic
Join Date: Mar 2010
Location: GUAHAN
Posts: 1,198
Drives: To & From then Back
Rep Power: 3400   |
I also had this problem recently...it happened to be my pins on MAF1 going to Bank 1, right at the end of the pig tail. Apparently when using the Stillen Extension Cables on the original Stillen set up (A2W) it had widen the gap on the original MAF harness pins under the pigtail. Due to the new piping I only used the Stillen extensin cable on one of the MAF sensors (Bank 2). After straightening out the pins I was back in business. The loose/misaligned pins on the MAF pins was tripping out the MAF readings thus throwing the AFR'S and Idle.all over the place.
__________________
2013 Nismo Z34 / FI TT #091 / IG: @lilzilla_z34 |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is fuel starvation issue serious on street driving ? | felix0121 | Nissan 370Z General Discussions | 21 | 02-09-2017 07:34 AM |
| Gtm supercharger issue | Dante2009 | Forced Induction | 8 | 01-05-2017 11:03 PM |
| Stillen Supercharger post-install issues | WillVHR | Forced Induction | 6 | 01-29-2016 07:49 PM |
| help!! jerky launch.. rpm drops | binoy29 | Engine & Drivetrain | 16 | 01-30-2015 06:49 PM |
| Jerky at low RPMS | khtso | Nissan 370Z General Discussions | 68 | 03-16-2011 08:24 PM |
12Likes
Threaded Mode
