|
Title should say AFR guage how to: Ok, I am going to install Motordyne LT headers (midsize headers) along with resonator TPs and I have always wanted to install an
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
10-31-2017, 07:02 PM
|
#1 (permalink) |
|
Base Member
Join Date: Jan 2014
Location: PA
Posts: 120
Drives: 11' 370Z Nismo
Rep Power: 12  |
A DR gauge how to...
Title should say AFR guage how to:
Ok, I am going to install Motordyne LT headers (midsize headers) along with resonator TPs and I have always wanted to install an AFR guage but I dont know how the sensor gets hooked up. So my question is... On the right side header I have a bung and on the right side resonated TP i have a bung, same for the left side...however the z needs all of these for its computer so do I need to have a welder install two more, one on each side...or is there a way to split the signal and have the computer and the guage get the same signal from the same sensor? And if so, before or after the cat (if I had a cat)? /Z/ Last edited by imazman; 10-31-2017 at 07:05 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gauge pod | wretched_z | Exterior & Interior | 3 | 06-23-2011 05:13 PM |
| Oil Gauge... | JrumMusic | Nissan 370Z General Discussions | 7 | 06-11-2011 08:59 AM |
| How do you remove Gauge Cover & cover for tri gauge?? | Carbon_z | Exterior & Interior | 4 | 11-26-2010 09:07 PM |
| What happened to the tire pressure gauge and speedo in the middle gauge cluster? | rbratton | Nissan 370Z General Discussions | 33 | 01-24-2009 10:28 PM |
Threaded Mode
