Stillen Air to Air setup

JWillis72

Thanks guys.


Sent from my iPhone using Tapatalk

jwick

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build

TopgunZ

Here are the steel mesh ones. Save shipping cost and have them today.

Speed by Spectre 3995 - Oil Breather Cap | O'Reilly Auto Parts

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

JWillis72

I don't have a O'Reilly near me but I found a found a local place that has them. I have new MAF extensions from Stillen being delivered tomorrow but don't think they will change anything. I'm running out of ideas but trying not to give up.


Sent from my iPhone using Tapatalk

TopgunZ

Like I said. Put the old pipe back on. You won't have to take anything off to try it. It will take minutes and rule out so much.

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

JWillis72

We cut the old pipe for part of this one. Do you still have the vacuum like on the back of the Stillen manifold?


Sent from my iPhone using Tapatalk

EVOHUNTER

I have 4 lines going into the manifold, one right from booster to manifold other 2 too valve covers, and one goes to my purge sol.

I kept the same setup as stillen, only thing changed was the one line that goes into the coupler in the blower and the other side hooks up to your bpv.

instead of going into the coupler, sasha put it into the intake right after the filter.

__________________

TopgunZ

Evo. That coupler port is still the same as stillen did it. Its still pre blower. That's the only way to recirc.

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

JWillis72

It's all back together and still not acting right. MAF voltage is still off and the AFR on one bank is reading lower than the other after it runs a bit. We are to try the swapping MAFs then swapping wire again but last time the numbers stayed with the pipe. They are also going to get it back on the lift to check for exhaust leaks.

jwick

Have they smoke or soap tested it?

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build

JWillis72

Yes, they have smoked it a couple times. I'm in Ohio until tomorrow night but they seem to have had some luck SD tuning it. The shop is telling me if things go well in the morning that it could be in the dyno tomorrow but at this point I will believe it when I see it.


Sent from my iPhone using Tapatalk

TopgunZ

Waiting for the good news on the SD tune and that 500+ number!!!

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

DatsunFTW

Let me know when you're at the shop this week. I'll come by

__________________

JWillis72

Fuckers isn't answering me because I'm in Ohio! I'm at the airport now and will be there to see him when he opens!


Sent from my iPhone using Tapatalk

JWillis72

They can't tell me if it can be tuned at this point but he said I would know tonight. If the answer is no I'm done and the car is going back to how it was, well close as we can get it. Its a track car that has kept me from the track for six months and I'm over it. One way or the other this has to end and it has to end now.