Question!? Fujimura rear diffuser
 

Okay so I just got my fujimura rear diffuser in today from japan.

I just slapped it to check fitment but its touching my FI exhaust tip.
Is that bad? will it melt?

Post some pictures. If it still touches you may be able to have a muffler shop extend the exhaust hangers so that it can clear.

poop..... at work right now. gotta upload tonight. but yeah... they do touch.
So that means they will melt over time?

It's possible you can either place a heat shield there or take it to a muffler shop and have new hangers welded on. Oh and there are also rubber universal exhaust hanger pieces that come in different lengths that may also be a viable solution for you. You may have to get a little creative but Cusco makes some exhaust hangers and there are other brands out there

http://www.cuscousainc.com/media/cat...sthanger_1.jpg

http://www.cuscousainc.com/media/wys...ust_Hanger.jpg

Thanks Rep+

resin can melt. use a few washers on the muffler bracket (no need for new hangers) to lower your exhaust just a hair. i have about 7-8mm gap between my fujimura cf and cans. :D

That would work too

yah, the car guys' washer mod.... :ugh:

Can you rotate the tips down slightly?

The tips arnt welded on the fast intensions?? :ugh:

Was it borla dat gives you a puzzle of and exhaust to put together? Lol

I think it was Magnaflow that gives you the DIY exhaust lol

The Ikea of exhaust systems

http://images.magnaflow.com/02produc...s/16595_lg.jpg

Noooooo.. none of those wooden pegs or Allen wrenches... LOL

Like Kenchan said, I did add a few washers between the brackets and the body. It was not a super easy job to do but you should be able to DIY. There are three bolds on each bracket.