Find 2 photos of the same angle, one with hood up.

So basically the center vent is right about where it should be for optimal cooling. Thanks.

anyone think about using the mustang GT 500 vent?

I have seen one in person (just the vent), a co-worker was adding it to a Mustang GT hood. The Mustang hood is a bit more flat than ours and might not sit 'flush' if used, and the piece was not very flexible from what I could tell.

Just saw this hood pop up from TAS 2014 by Fujimura:

http://www.fujimura-auto.co.jp/origi...net-up-640.jpg
http://www.fujimura-auto.co.jp/origi...bonnet-640.jpg

Very interesting, coming from them I would imagine this is a functional piece.

INGS has a new one out, looks similar to the one found on the nismo RC in japan racing cars.

https://scontent-a-dfw.xx.fbcdn.net/...35822404_n.jpg
https://scontent-a-dfw.xx.fbcdn.net/...21130917_n.jpg

Middle vents WAY too big! :ugh2:

Aerojacket SS hood in CF. Vents are very functional, I could feel the heat coming through them.

http://www.the370z.com/members/ripti...ure75225-a.jpg

This has to help get some heat out but it's been to cold around here to tell.

Odd it's not sideways on my computer?

Can you get a clean above the hood shot (looking down), curious how it compares to the Seibon TS in terms of the openings.

Here you go.

The back ones were over the battery and break boxes.

^Love that hood.

I really like this design, very different from anything else out there.