Good to hear! They look great by the way! Mind posting up pics of the brackets? :)

Hey guys, hate to bump this old thread but I really some help.

I've got the Aerojacket spats. They are good finish, but don't seem to fit. I don't have brackets. For the last three weeks I've tried affixing them with 3M tape (4000 series) and the 2 supplied screws, Sikaflex adhesive (227, 252), 3M VHB tape, various industrial tapes, but the spats will peel away from the body after 24hrs.

I'm not very mechanically minded so making the bracket isn't an option for me, can I buy them from somewhere? Would they help solve my issue?

Go to Home Depot, or whatever you guys have over there, look at brackets. Put in a vice and bend by hand.

I'll give this a shot. Does anyone have any photos of the Sunline ones I can use as a reference?

First page on this thread.

i think they have something similiar to that in the door section?

Went to the Sunline link - and the spats are over $1k??? Back to Z1, thank you...

Are y'all removing the factory splash guard? I test fitted the shine spats and they fitted right over them.

I did... remove them that is...

Go Seibon brother.
Ils sont les meilleurs:tup:

Ok which one you think guys better in workmanship with CF rear spats shine auto or aerojackets? Im about to do this but which brand is better?
Thanks.

Hey guys
 

Can anyone help,I have a problem,I have brackets screws and all but my 3m acrylic double sided is just not sticking to keep it flush on the end part where spats sit on top of exhaust.anyone know what I can use.

Yeah I just got a set of these - funny thing is they came from EVO-r's factory in Taiwan. They arrived fine but passenger side has a pea sized dimple in one side - I will have to get my body shop to fill in and paint.

But yeah the fitment of these kinda worry me - I am sure my body shop will use double sided tape but they essentially fit like crap. And they should have provided a bracket or something for additional support underneath.

Will bring these to my body shop tomorrow - to see what they think :confused:

Just bought these from a member. I can't see the initial Sunline bracket picture, but from what I can gather, the bracket goes from the bottom bolt hole (I have two holes on the spats where the mud guard front would be)....to where? I haven't tried installing it but am not seeing where the other side of it would go, unless the bracket is basically just bracing the bumper from the top hole to the bottom hole on the mud guard area.

Also, any opinions on which 3M double sided tape to use? I remember using one on my old car for the front license plate, but the tape was kind of thick (1/8"?). I was worried using something like that because of the gap between the bumper and the spats. It did hold though.