Nissan 370Z Forum - Can you change the time in the clock gauge?

Nissan 370Z Forum (http://www.the370z.com/)

- Exterior & Interior (http://www.the370z.com/exterior-interior/)

- - Can you change the time in the clock gauge? (http://www.the370z.com/exterior-interior/45346-can-you-change-time-clock-gauge.html)

Quote:

Originally Posted by frost (Post 1405364)

But the Nav one is the accurate one!!! http://www.sherv.net/cm/emo/angry/pulling-hair-out.gif

Maybe so, but I can't change the gauge clock to anything else. So rather than have two clocks or do some major mods, I just turn the nav off. Accurate enough for me, and it takes mere seconds to change if need be. I don't know about you, but my life is not THAT tied on the minute.:eekdance::p

The clock is a pain in the arse to change until you get used too.

No nav, but my normal clock is spot on with my phone (main time piece) i only have to change it for day light saving.

There is actually a TSB issued on setting it but check pg 2-22 Instruments and controls in the owners manual. Here is the info from the TSB...

370Z COUPE AND 370Z ROADSTER; TRIPLE METER CLOCK SETTING PROCEDURE

APPLIED VEHICLES: 2009-2010 370Z Coupe 2010 370Z Roadster

Classification: Reference: Date: EL09-039 NTB09-109 October7, 2009

SERVICE INFORMATION
If the clock (located in the Triple Meter, above center in the instrument panel) needs to be set, use the procedure starting on Page 2.
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
3
Combimeter
NOTE: Refer to Figure 1 on Page 1 for component location.
1. Turn the ignition on.
2. Press the Enter switch repeatedly until “Setting” shows in the upper right of the Vehicle Information Display.
3. Press the Next switch repeatedly until “Clock” is highlighted.
4. Press the Enter switch once.
5. Press the Next switch repeatedly until “Setting” is highlighted.
6. Press the Next switch repeatedly until the desired hour value is reached.
7. Press the Enter switch once.
8. Press the Next switch repeatedly until the desired minute value is reached.
9. Press the Enter switch once.
10. Press the Next switch repeatedly until “Back” is highlighted.
11. Press the Enter switch repeatedly until out of the setting mode.

Wow, I am sharing the road with people who need manual to adjust clock on their Z.

Quote:

Originally Posted by awesomez (Post 1410476)

Wow, I am sharing the road with people who need manual to adjust clock on their Z.

:iagree:

Quote:

Originally Posted by awesomez (Post 1410476)

Wow, I am sharing the road with people who need manual to adjust clock on their Z.

Kinda mean but I sort of agree! lol