MOMO Trek Steering Wheel and Red PW JDM Shift Knob Installed.
 

Finally got my MOMO Trek Steering Wheel, NRG Short Hub & Quick Release 2.5
and a Red PW JDM Shift Knob installed. Got bored and got these. The only
issue I'm having is despite having 2 airbag resistors, the SRS light keeps
blinking like VDC keeps kicking in lol. Special thanks to Scott B. of Relentless
Autosport and Dat N. of Speed Alliance for excellent service!

P.S. Sorry for pics, aside from it coming from my phone, the car is pretty dirty. :roflpuke2:

try a srs reset and see if it goes away. i forget wat ohm to use but if it's too much it will blink, if it's too little it will blink as well. :)

looks good! Just enough red not to make it look busy IMO
Noob question: do you lose your front airbag when u do this mod? Is it safe?

Is that the one Mr. Kenchan that you put the ignition to ON, then after the
SRS blinks once, turn ignition to OFF. And then repeat at about 3 to 4
times???

Thanks for the compliment sir! Yes, the airbag is gone. I kept it in a safe
place in case I'd sell the car or if a cop gives me a hard time. :roflpuke2:

sorry i dont remember off hand but check the audio section cause stereo newbs usually forget to plug the SRS indicator thingie on the passenger side and have to do this sequence. :D

I had that steering wheel 3 cars ago. I liked how it felt. :tup:

Nice setup. Looks great.

I hope to have a Nardi wheel soon. How to you like the NRG short hub and quick release. I'm looking at that also.

Fixed! I found a thread in here on how to fix it. Thanks!

I didnt go with Nardi steering wheel coz I'm not into deep dish but they do look good though. For the NRG, they're a great company, as for the hub and QR, I cant get any happier - but! I may switch to a QR 2.0 instead.

Looks good man! Glad it finally worked out for you! What did you do with the nismo knob?

Thanks dude! I stored the knob back to it's original packaging. You wanna
buy it? :stirthepot: