B Pillar Finisher Grommet Replace

JARblue

Are you sure you need to replace the grommet? There's a pawl on the back side of the b-pillar that is easy to break off if you aren't careful. It inserts into the grommet.

If that grommet is what you need, I guessing you won't find it at an auto parts store. It looks like what you need is identified as 78100H in this diagram.



https://parts.nissanusa.com/p/Nissan...848-35F00.html

__________________

MSC43

Yes. Long story short I had to replace the Finishers from a bad windshield replacement....they broke the finishers trying to remove them...I messed up the grommets trying to remove the broken piece from the finishers that was stick inside.

JARblue

I'm guessing the idiots tried to glue the piece back into the grommet after they broke it. Common half assery...

https://www.service8.com.au/nissan-3...illar-removal/

__________________

MSC43

Nope. Duct Tape. 😅.....For some reason that top piece is built into the finisher and not like the bottom two.

JARblue

Yup... that's the kicker. That one almost always breaks if you haven't done it before. I keep extras of the other clips around because those break as well but can be easily replaced.

__________________

zeeder

I've had the B-Pillar come off and the top clip has broken off. The bottom clip is still intact and the middle clip is intact but has released from the B-pillar cover. Is there a, reasonably, easy way to get the broken clip out of the top. If I do this, can I just replace the top two clips or will I need to purchase a new cover as well?

B-Pillar.jpg

__________________
Zack
FI catback, HFC, and Start Button - Z1 Intake - Nismo S-Tune Spoiler - PasswordJDM V2 Shift Knob