One clip broke, and deal says I need to replace the entire thing??

TreeSemdyZee

OK OP.

I checked, I don't have one of those clips.
The mechanic is an alarmist. The clip cost less than two dollars.
If you very carefully lift up on the pillar, similar to what you are doing in the video, You can get that clip out of there and slide in a new one.

See attached PDF. When you lift up on the finisher, there is a "saddle" that sits over a nib in the body. About 3 or 4 inches back.
If you carefully lift straight up, you should be able to replace that pin.

Attached Files

Page 34 from EXT.pdf (221.2 KB, 17 views)

__________________
Borla S-Type | Motordyne | Z1 (lots) | South Bend | K&N | Nismo/Nismo S-Tune | Eibach | Aerojacket | Fujimara | Spl | ZSpeed Performance | Kenwood-Infinity-Sound Ordnance | Whiteline | Ecutek | Hotchkis | Clazzio | VQ Vortex |Morimoto XB |Dynosty Tune 329.64hp 265.73 ft/lb

KrnAndy

thank you for that pic, even at the dealership they opened up a diagram and looked they couldn't figure out what clip that was. I'm guessing it's what the A is pointing to. Not completely sure but in the second picture is that other "A" pointing to a bolt holding it in place behind the door?

how would you pop that clip out without breaking it?


here's a better video of where it snapped, for those who asked
https://youtu.be/ECfhtp2ql10

also what kind of clip is that called? (so I can order a new one, maybe two if i break the one behind the door)

TreeSemdyZee

That piece in the pic is not actually a bolt. It's a pin that the pillar "saddles" or slides over it.

I'd put a screw driver underneath the clip to push it out of the hole. Just below the "A" in this pic.

__________________
Borla S-Type | Motordyne | Z1 (lots) | South Bend | K&N | Nismo/Nismo S-Tune | Eibach | Aerojacket | Fujimara | Spl | ZSpeed Performance | Kenwood-Infinity-Sound Ordnance | Whiteline | Ecutek | Hotchkis | Clazzio | VQ Vortex |Morimoto XB |Dynosty Tune 329.64hp 265.73 ft/lb