Nissan 370Z Forum - Cracked windshield washer reservoir

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Engine & Drivetrain (http://www.the370z.com/engine-drivetrain/)

- - Cracked windshield washer reservoir (http://www.the370z.com/engine-drivetrain/99693-cracked-windshield-washer-reservoir.html)

6MT-Z34

01-08-2015 09:20 AM

Oh I see...maybe its cover under your warranty??

jwick

01-08-2015 09:21 AM

Quote:

Originally Posted by wsarver (Post 3075901)

I repaired a crack on my old frontier using a plastic jb weld. Sealed it right up and never had to revisit it. What's a tube cost less than 10 bucks?

That's what I was thinking. That or I know Eastwood sells a plastic repair kit for around $20.

jwick

01-08-2015 09:22 AM

Quote:

Originally Posted by Solid370z (Post 3075913)

Those I have

Came across that link on Google. But I'm hoping I could seal the crack otherwise I will replace it. Also, my car was bought from a dealer in WI.

Removing the bumper is pretty quick and easy. I can have mine on the ground in under 10 mins.

juld0zer

01-08-2015 05:23 PM

you dont need to take the bumper off. it can be done by removing the right fender liner. Follow the instructions for fitting the AEM CAI

jwick

01-08-2015 05:26 PM

Quote:

Originally Posted by juld0zer (Post 3076322)

you dont need to take the bumper off. it can be done by removing the right fender liner. Follow the instructions for fitting the AEM CAI

Can you remove the tank from the fender? Even if you can I would argue it is faster to drop the bumper than remove the tire and pull the liner

MJB	01-08-2015 05:35 PM

Quote:

Originally Posted by jwick (Post 3076326)

Can you remove the tank from the fender? Even if you can I would argue it is faster to drop the bumper than remove the tire and pull the liner

Yeah, the tank is held in by 3 screws... I don't think you can get to two of them unless you take the bumper off...

juld0zer

01-08-2015 06:03 PM

yep it's accessible from the fender. all bolts are accessible too. the only part that isnt is the neck which you rotate while pulling upwards after removing all fasteners from above.

You guys are lucky because you dont have headlight washers and dont have pedestrian protection hood mechanisms. The latter is why i hate removing the front bumper, because of the 3 impact sensors attached to the bumper which have very short looms.

Solid370z

01-08-2015 06:04 PM

Thanks for your suggestions. I will try to check when the weather gets better.

juld0zer

01-08-2015 06:05 PM

pg 7:
http://www.aemintakes.com/instructio...-1001_inst.pdf

All times are GMT -5. The time now is 11:06 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page