That's just what custom set of Burns Stainless or Coast Fabrication headers cost.I can't remember who built the first set. But now they are a little cheaper.
They are equal length, 3 stage stepped, long primaries.
Not sure they would be ideal for a street car as they are spec'd for the engine build.

Equal length, 3 step, lth...sounds a lot like PPE's headers. I'm guessing the materials and collectors are better though. I just looked on Burns Stainless's site and they have hourglass shapes at their ends which current headers for our cars do not.

From looking at the pictures of the PPE headers..I would say we have different diameters as well as longer primary length...merge collector is a lot different on ours.
Not sure what one side of ours weighs exactly but it's no much at all.

no pics? What the specs on your headers?

I do not have pics of our headers.
We only have one set and they are installed.

Since Im considering headers i was told not to go cheap and was looking for a good solution. I dont care about labor but around my area i just could find any trustworthy shops that know what there doing. If i do it myself and get far and screw up somewhere theres no turning back

Is there a question in this..? :confused: