how do you recover from limp mode

christian370z · 10-08-2011, 03:03 PM

You should reset the ECU. Pulling the negative cable is one way, but you can also use this technique to avoid having to set the windows.

Quote:

Read the process a few times before you try to do this its ALL ABOUT TIMING:

1) With the key in your pocket/car, push the Engine Start button TWICE (so the car is fully on, but not started)
2) Within three seconds of the car "ON" (again NOT started), Floor (all the way down) and Release the gas pedal fully 5 times within 5 seconds. Do not do this too fast.. 1..2..3..4..5
3) Wait 7 seconds then floor the gas pedal and hold for 10 seconds. After that 10 seconds the Check Engine Light will start to blink slowly.
4) Release the pedal and floor it down once again and hold for 10 seconds. After these 10 seconds the check engine light will disappear then begin to flash much more rapidly. After you have done the following turn the car off and then back on. The ECU is now reset!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Limp mode @ 3.5k rpm; no cel	zilent_jay	Nissan 370Z General Discussions	56	08-28-2012 09:44 AM
Limp mode troubles?	Bill Gephardt	New Forum Member	0	05-14-2010 06:15 PM
limp mode even with oil cooler!	boosted180	Track / Autocross / Drifting / Dragstrip	7	09-20-2009 02:58 PM
Possible limp mode?	DinoJ	Nissan 370Z General Discussions	21	09-04-2009 04:17 PM