Innovate dlg1
 

Anyone running an innovate dlg1? How the heck did you get the wires routed through the firewall. I tried going the same way I have my fuel pump power wire routed (behind the battery) but the connector is pretty thick, I would have to enlarge the hole a fair bit (there's two cables/connectors that must pass through, one for each bank o2 sensor).

https://i.imgur.com/Q7I0kSK.jpeg

The large grommet behind the battery area is where I pass all my wires and crap through. Stole these pics from oil pressure gauge thread.

http://www.the370z.com/members/spear...4-img-1409.jpg
http://www.the370z.com/members/spear...9-img-1410.jpg

After you pass the wires through where Madwi showed. Put some RTV around the hole so that it doesn't leak.

So, not directly related to my initial question but if anyone comes across this thread in the future while looking up the dlg-1: If you install the o2 sensors slightly down stream (mine are just after the test pipes, in the Y pipe), the cable from the o2 sensors will not reach the gauge no matter how much of a direct path you try to take, it's off by 1-2 feet. You'll need an extension (not sure one exists). Innovate sells an 18foot cable that will work, you'll just have to hide the excess under the carpet or something I guess.