DIY: Tein EDFC II (or I) Controller and Motor Kits Install

ENT-Z · 01-14-2015, 08:04 PM

Nice write up. I have the EDFC Active with the GPS and G sensors and love it.

Orestp · 01-14-2015, 08:09 PM

Great write up on the EDFC install - any issues reinstalling the strut tower brace after the EDFC motors have been installed? Is there any clearance issue or issue keeping the wire from the EDFC motors clear of the strut tower brace?

Master_Ly · 01-15-2015, 06:30 PM

Quote:

Originally Posted by Orestp

Great write up on the EDFC install - any issues reinstalling the strut tower brace after the EDFC motors have been installed? Is there any clearance issue or issue keeping the wire from the EDFC motors clear of the strut tower brace?

No issues with the strut tower brace. The EDFC motors are very low profile and sink pretty deep into the top of the struts. I believe the EDFC motors are the same and just the controllers is what's different. The wires can be in the way so you'll have to cable tie them down using your best judgment so they stay out of the way.

01-14-2015, 08:04 PM	#1 (permalink)
ENT-Z Enthusiast Member Join Date: Feb 2009 Location: St. Louis, MO Posts: 460 Drives: 09 MB 6MT 370Z Rep Power: 18	Nice write up. I have the EDFC Active with the GPS and G sensors and love it. Master_Ly likes this.

01-14-2015, 08:09 PM	#2 (permalink)
Orestp Base Member Join Date: Jul 2011 Location: Edmonton, Alberta Posts: 43 Drives: 2010 370Z Rep Power: 15	Reinstall Strut Tower Brace Great write up on the EDFC install - any issues reinstalling the strut tower brace after the EDFC motors have been installed? Is there any clearance issue or issue keeping the wire from the EDFC motors clear of the strut tower brace? __________________ GTM Twin Supercharger / GTM Large Capacity Oil Pan / GTM Valve Body Upgrade / Setrab 34 row oil cooler <- Deleted, Replaced with Laminova water to oil oil cooler / MotorDyne ART pipes / Cusco RS LSD / Tuned by Specialty Z / 15mm Ichiba spacers front & rear

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Finished TEIN Monoflex with EDFC install	Nikon FM	Brakes & Suspension	63	10-10-2016 02:13 AM
DIY: Tein Monoflex Coilovers and SPL Camber Kits Install	Master_Ly	DIY Section (Do-It-Yourself)	26	06-25-2016 12:25 PM
EDFC Motor for Rear Tein Mono Flex - Where?	Master_Ly	Brakes & Suspension	2	07-13-2014 05:27 PM
TEIN EDFC w/KW V3?? Possible?	KusoSama	Brakes & Suspension	11	04-29-2011 07:49 PM
EDFC (Electronic Damping Force Controller) WTF!!	bluestyle55	Brakes & Suspension	12	03-03-2010 12:25 PM