|
I just did this and here is what I learned. Once the one nut and two bolts are removed there are two clips that hold the light housing on. The
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-24-2016, 09:41 PM
|
#12 (permalink) |
|
Base Member
Join Date: Jan 2013
Location: CA
Posts: 26
Drives: 13 Nismo MagmaRed M6
Rep Power: 13  |
I just did this and here is what I learned. Once the one nut and two bolts are removed there are two clips that hold the light housing on. The top one is blue and the bottom one is red. Grab the light and pull straight back to release the pins on the light housing from the clips on the body of the car. I recommend putting tape on the upper corner of the bumper where the corner of the light meets the body/ bumper. Look carefully at the front corner of my bumper and you will see where the front lower tip of the light chipped the paint. (near the black circle piece).
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY REMOVAL OF THIRD brake light!!!!!!!! | simota1 | DIY Section (Do-It-Yourself) | 33 | 10-04-2022 07:51 AM |
| tail light out warning light | cossie1600 | Exterior & Interior | 0 | 06-28-2011 08:15 PM |
| Local 370z needed for smoked tail light and head light fitting | dantegts | Southern California Region | 11 | 04-07-2010 07:55 PM |
| smoked tail light and head light volunteer covina, ca area | dantegts | Exterior & Interior | 0 | 08-29-2009 12:33 PM |
| + Removal of Tail Lights + | batman_4 | Exterior & Interior | 34 | 06-22-2009 07:26 PM |
5Likes
Threaded Mode
