09-10-2012, 03:23 PM
|
#19 (permalink)
|
|
A True Z Fanatic
Join Date: Jun 2011
Location: Toronto
Posts: 28,894
Drives: 2011 ZR PW w/Clutch
Rep Power: 418354
|
Quote:
Originally Posted by The Z monster
Hey did u ever get any hissing noises after u installed it? I keep hearing this hissing noise and I don't know if it's the intakes or what. It's aggravating.
|
Yes... there's a slight hissing noise at certain range, I've checked the hose and clamps and they are all tight, it is normal from the filters.
Quote:
Originally Posted by SalA
Thanks Man..I found your added instructions very helpful. Just a general comment to the thread...Everything was as the instructions suggested...The driver side crank case venting outlet takes the two 3" rubber tubing as a 90 degree setup..and that is a good fit. The instructions state to use the 7" tubing "as is" for the passenger side crank case vent. You just cannot install the 7" piece without a sever kink..As you stated it must be cut to size....Approximately 3" should do it...but measure first.
I immediately felt a difference in response and sound. A really good modification for the money and effort!!
|
 Great, I am glad you found my write up is useful!! What's the next mods???
|
|
|
Similar Threads
9Likes
Threaded Mode
