DIY: Level out your exhaust

redline727

Drivers side: Before
SAM_4854.jpg
Passenger side: Before Unacceptable for my OCD
SAM_4855.jpg
Tools required: ratchet with 12mm socket and extension
SAM_4856.jpg
Unbolt hanger bracket that needs spacing so you can level out the tips
SAM_4858.JPG
Remove hanger bracket
SAM_4859.JPG
Take to your local steel fab shop, (if you have one) tell them you need a spacer made for however off your exhaust is. (mine was 1/4") I chose to use stainless steel bc it was a small piece and only cost me $30.00 to make, plus it was going to be under the car and exposed to the weather. You could use aluminum and powder coat it but would probably spend more doing so. if you have a weird measurement you may need to have multiple spacers of different thicknesses and stack them or do both sides to get just right. I guess in this sense I was lucky. Some people try to bend the hangers on the exhaust itself, but could end up with less then desirable results. The way the exhaust on the 370 is setup this seems the most logical way to correct it. No floor jack or removal of exhaust required. (smarter not harder right?)
SAM_4860.JPG
Took a couple hours to fab up,(picked up the next day) here is the result:
SAM_4861.JPG
It looks real good to me!
SAM_4862.jpg
Bolt the hanger bracket back up with the spacer inserted
SAM_4864.jpg
Drivers side: after
SAM_4866.jpg
Passenger side: after, much better
SAM_4867.jpg
Now I can sleep knowing my exhaust is not uneven
SAM_4869.jpgl

__________________