How to rice out your Z to the max vol.1 <Carbon Fiber film your B-pillars>
 

Hey guys,

I'm not 100% sure if anyone else has uploaded same DIY yet.

However, I decided to start off my "How to rice out your Z to the max" series

with installing carbon fiber film to Z's B-pillars.

Installing this part will add approximately 25RWHP to your Z.

1. Required tools are [ scissors, 3M Dinoc Carbon Fiber film, marker, hair dryer ]

2.This installation is very easy. It only took me about 20 minutes (first attempt).

I'll be wrapping few of my forum friends' Zs tonight and expect to install them

in about 5 minutes.

3. You start off by cutting 3M film to approximate size by folding them(or you can measure)

4. You then mark them to better fit to your Z.

Hardest part is cutting one side of B-pillar as indicated by red circle on the pic.
http://dcimg1.dcinside.com/viewimage...a4728bd13fa1d6

Marked area does not have any space to tuck in your excess film.

Therefore, you'll have to cut it to perfection if you want it to be perfectly done.

5. Prefit your film to your B-pillar
#############Do not stick it on to your car, YET.##############

6. Now you make a copy of the film for the other side.

This process can be done by putting cut film onto another film and marking

them.
http://dcimg1.dcinside.com/viewimage...a47285d13fa1d6

7. Now put them on your car. First fitting the marked area and lastly towards the other side.

8. Heat the edges and wrap so that it won't start peeling later on.

9. Now your car has extra 35 horsepowers.
http://dcimg1.dcinside.com/viewimage...a4728ed13fa1d6
http://dcimg1.dcinside.com/viewimage...a47289d13fa1d6
http://dcimg1.dcinside.com/viewimage...a47288d13fa1d6

*** My next "how to rice out your Z to the max" vol.2 will be on FairladyZ emblem.

Lmfao

Rep + 1

awesome DIY. rep + will be doing this tonight!

nice job. man, i should've considered doing this on the stereo bezel while i had the HU out... im too lazy to take it apart again just to do this. :D hahahaha.

looks good. btw, do they have the glossy finish films too? :confused:

Nope, I think it's semi glossy... there's only 1 type with difference colors eh

cool! now it looks like Audi r8 !!!!!

where can I buy the 3M carbon fiber film?

Nice Job! If you have the Dyno results to back up the increased RWHP number I'll give you Rep. :)

Putting this cf sticker on the exterior is ghetto and ricey...lmao!

i see, thanks for the info. my other cf bits are all glossy so i suppose this film isn't for me.

Looks better than the Spawn Aero b-pillars

plus you can use the leftovers for your ipad. :D

I wrapped 2 other friends' cars' B-pillars and also I wrapped my key... lol

check this out lol

haha!