![]() |
Hey Alstann, I just got my KW V3 installed recently and I'm ready to take it in for wheel alignment. I currently have the ride height almost the same as
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#4 (permalink) |
|
A True Z Fanatic
Join Date: Jan 2009
Location: Nor Cal
Posts: 1,113
Drives: with his eyes close
Rep Power: 719 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
Hey Alstann,
I just got my KW V3 installed recently and I'm ready to take it in for wheel alignment. I currently have the ride height almost the same as the OEM setting. But from the KW V3 factory recommendations is below: Front/Rear: 9 click and 1 turn from close for Rebound & Bump. As for the ride height, if you didn't measure the height prior to uninstalling. OEM Manual states: Wheelarch Height (from ground to arch) for 19" Front: 27.87" Rear: 27.99" After my install (The highest the rear is allowed to go): Front: 27.25" Rear: 27.3125" Currently drives like stock can clear anything, but since I track my car, I'm not wondering if I should lower it a bit more. Also, anything lower than this, you may have a hard time accessing the jack points without driving your car on wood blocks prior. |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Timing adjustment and FI. | Ron | Forced Induction | 11 | 07-05-2020 10:38 AM |
| Seat Adjustment | ZzzZz | Exterior & Interior | 8 | 09-26-2010 01:04 PM |
| Valve Adjustment | 370zFORme!! | Engine & Drivetrain | 34 | 04-22-2010 02:21 AM |
| Clutch Adjustment | m4a1mustang | Engine & Drivetrain | 10 | 10-30-2009 11:56 AM |
| Toe Adjustment | BrianUSMC | Nissan 370Z General Discussions | 4 | 10-03-2009 07:39 PM |