Spacers Question!?

[andrewkd16]

lowered the nismo on h&r springs decent drop for springs about a finger/half gap so its by all means not "slammed" but i do want to do spacers but which should i go with and what size for front/rear??? 15mm rear and 10mm front? if anyone else has done this just let me know what will work and be the best quality i dont want cheap ones.

thanks

[370zFORme!!]

I would say at least 20mm in the back. Also go with h&r spacers, they are higher quality and the hub is welded to the actual spacer.

[kenchan]

I think the front needs more help than the rear. Most folks use larger offsets in the back but imo its the front that needs a bigger width from a cosmetic point of view...and turnability.

[fuct]

Originally Posted by kenchan

I think the front needs more help than the rear. Most folks use larger offsets in the back but imo its the front that needs a bigger width from a cosmetic point of view...and turnability.

15mm is as far as you can go on the front. i rub the factory advans on bumps.

side note the tein springs give the car a on efinger gap, not 1-1/2. even though everyone says the H&R have such a large drop.

OP, learn to search bro!
H&R 15mm spacer intall front and rear

[Red__Zed]

I'd go 15/15 or 15/10 for a Nismo on HR's

[Fire]

I cannot speak for the Nismo but this is what I have on my roadster. 20mm front and back with eibach springs(stillen). I just rub slightly with hard decelerating left hand with a 250 pound driver. Take Care.