|
My final solution was a 4 inch height, 2.5 inch diameter, 600lb/ft spring from Eibach We were able to trim the spring perch without machine work, it was thin enough
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
01-25-2024, 06:11 PM
|
#1 (permalink) |
|
A True Z Fanatic
Join Date: Apr 2011
Location: Sacramento
Posts: 3,270
Drives: 15 370Z Nismo 6MT
Rep Power: 214102   |
My final solution was a 4 inch height, 2.5 inch diameter, 600lb/ft spring from Eibach
We were able to trim the spring perch without machine work, it was thin enough metal we could take a centimeter or so off the top and that was enough to clear everything on compression When planning your final height, the stance cup adds MORE than an inch. Their measurements said 30 mm or so but there's no way it was that. It's more like 1.5-2 inches since I had to go down from a 6 to 4 inch spring. keep that in mind when thinking about where you wanna end up and your rear spring length/suspension parts planning If you don't care about being stance-low, you will have an easier time than i did
__________________
OptionZero Build Thread |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FOR SALE] (SOCAL) BRAND NEW - TEIN FLEX Z w/ STANCEPARTS AIR CUPS | lumpia.z | Parts for sale (Private Classifieds) | 12 | 09-29-2018 12:16 AM |
| DIY:Navigation System Install to a Non Navigation Z Project | simos3laf | DIY Section (Do-It-Yourself) | 5 | 01-14-2018 03:45 AM |
| StanceParts Air Cups? | pierce | Brakes & Suspension | 1 | 04-29-2017 10:26 AM |
| Tire Temperature System Project | mikes603 | Track / Autocross / Drifting / Dragstrip | 4 | 07-21-2014 06:49 PM |
| ARK PERFORMANCE USA dot COM : 370Z/Z34/VQ37 GRIP EXHAUST SYSTEM FULL CATBACK SYSTEM | TeamARK | Intake/Exhaust | 25 | 09-01-2011 11:27 AM |
38Likes
Hybrid Mode
