**NEW** RGB (Color Changing) MAP Light LED Pods

XwChriswX

The install on these is EXTREMELY simple. The only tools required are a very thin tipped Flathead screwdriver, and your hands.

Installation DIY:

1. Use the screwdriver to pry out one corner of the cover plate, then pull it off the other 3 posts.
   
2. Remove old bulb.
   
3. Insert plug for new LEDs (Do a quick On/Off test to make sure they work)

   **If they do not come on, simply unplug, flip plug, replug and do it again. These are polarity specific.

4. Do quick cycle check of all features to confirm everything works.
   
5. Peel off 3M adhesive cover paper, Press to inside of cavity for 30 seconds with decent pressure.
   
6. Tuck wires.
   
7. Replace Cover plates.
   
8. Enjoy.

I can tell you I previously had a 12 LED chip in there, and with now only having the 6 LED pod, it is WAY brighter. 9 of these LED's would just be ridiculous.

__________________

Bonnie - Stage 2, Audio build coming this fall!
R.I.P. Abby 3/29/10 - 3/30/14