Show me your custom rear hatch floors
 

Not sure if this belongs in the interiors section or here, but figured audio is probably the reason people have done custom floors in the hatch area, so here goes..

I'm making some changes back there and need to basically build my own floor. I currently have the wicked cas spare tire enclosure but thats not going to work for me anymore. Spare tire is coming out and will be replaced by other "stuff".

Wanted to see some examples of what people have done.. my thoughts are its going to have to be multipiece because of the angles on the sides, but want it secured well so that it won't be an issue during spirited driving or the off chance i make it back out to the track..

So if you don't mind sharing, post up some pics por favor!

Subbed for pics.

This is Chinooks (Lee's) Hatch,

http://www.the370z.com/members/chino...unk-lit-up.jpg

Box is secured with spare tire bracket
Floor is laminated with formica
Sub grille is frosted plexiglass

Ron so that first pic, I'm assuming your box is separate piece from the floor itself right?

I use the Wicked C.A.S. Box
http://www.wickedcas.com/gallery/d/11671-3/DSCN4863.JPG
http://www.wickedcas.com/gallery/d/11719-3/DSCN4909.JPG

ya i have that wickedcas box now and can't use it anymore thats why i'm asking for anyone who has done custom stuff.

A wood box I built that sits on my spare tire.
http://img.tapatalk.com/d/14/05/01/ane6upuj.jpg


Sent from my iPhone using Tapatalk

Correct. I installed the box and its top plate first, then cut my finished floor piece, which is split down the center... Layed it into place, and drilled through in a few spots for locating dowels, removed both sides of the finish panel, and applied laminate.

The entire assembly can be removed in about 15 minutes with a Phillips screwdriver and a 10mm wrench.

Thanks.. keep em coming.

Don't mean to go too far off topic of your discussion but does the Wicked CAS spare tire enclosure have the option of going completely stealth?

I see on their site they have the option of getting new rear carpet with the cut out for the sub to perforate through but I am wondering if there is an option for it to remain concealed.

I have the factory carpet over it and there is a bit of a bulge in it. If you were to remove the grating on the sub you could probably just sit the carpet over it with no issues. You would have to take care not to drop anything on the sub however.

http://www.the370z.com/members/reeps...unk-no-mat.jpg

http://www.the370z.com/members/reeps...-floor-mat.jpg

^ damn thats got to hit hard.

http://www.the370z.com/members/cbtec...tealth-box.jpg

http://www.the370z.com/members/cbtec...ure65047-6.jpg

http://www.the370z.com/members/cbtec...ure65048-4.jpg

http://www.the370z.com/members/cbtec...ure65050-2.jpg

nothing was put away in this pic...

http://www.the370z.com/members/cbtec...pec-jl-10w.jpg