Thanks guys; got everything but the beeping function when locking the Z using the door button. Any ideas? Like I mentioned before I already tried pressing n holding both buttons from the remote and it did'nt work.

The reset procedure for FOB and Lock / Unlock on the 2013-2009 is all the same. It's a timed procedure. I have been helping others in the area with theirs and it was the same symptoms. You will have to depress the buttons within range at the same time and hold them until you hear the car honk/beep 2 times which turns it off if recall, and then do it again, same procedure till it's 3 beeps honks etc, and then test. IT should be reset by then. I will confirm when i get mine back from the dealership. Mine is in the bay there now for the 3rd time with Failed Clutch CSC and assy. Ughghghghg :(

So guys I still have the problem of the car not beeping when i close it using the door button in the handle. I try several times the press n release in the remote but it didnt work. What else should i try?

Anyway as far as my sound system i end up installing the SPR 60C these been amped by a KTP 445 and controlled by an INE W927. Well, now i want to add bass. I ordered a Focal IBUS 20 thinking that it would fit under my passengers and it doesnt. Since in order install this unit I would end up sacrifying some hatch area and I wanted to keep it stealth I decided to return the Focal and started looking for and enclosure. This is my dilema i dont want to kill the sound of my components (45 amps) and i dont want any ratle instead a good balanced bass; with this being said i dont care for a 12". I had in mind an SWR 8D4 or an SWR 10D4 this using an MRX M55 (350 RMS @ 4 ohm). Im getting a knob controll so i can easily turn up or down the bass. Im trying to keep everything Alpine but open for some other brands (i know JL's are gd stuff 2). With this being said what size of sub and what amp need to be used so these could all come together. Thanks in advance for the inputs guys.:hello:

Just a note on rattles; I found the Z can produce rattles with even a modest sub depending on where it is and how low you go. I ended up using felt tape where panels met plastic or metal. Worked like a charm.

You might not have this problem, so don't go chasing windmills, but just in case.