[Help] Finding the crimp terminal part to wire in camera.
 

Hi, does anyone know where to get this part with correct dimension as in the picture?
http://img27.imageshack.us/img27/498/t4o.png
With this, we can add an RCA wire to the existing connector on the back of the HU to add a camera in.

Note: The connectors on the back are TH24FW-NH (Female) and TH24MW-NH (Male)
The above terminal goes inside the little square holes in this plug.
http://img59.imageshack.us/img59/2152/7ln3.png

you can get these at radio shak, they should have them in the bins. That is just a normal pin for most harnesses. The size may be a lil hard to find. But im sure if you ask someone there they could check and see if they have them in stock. If you still have no luck you can always unpin a aftermarket wire harness and use one of those. Its a bit of a pain in the a** to do it without breaking the pin because they break easily, but it can be done.

Thank you for the suggestion. I guess I can just buy this and have 20 tries to pull out 2 intact pins.

http://img594.imageshack.us/img594/3791/1orj.jpg

that would work...lol..

Get a "pin extractor"* and your success rate will jump from close to 0% to close to 100%.

* Just the first example I found; not a recommendation (but it does appear to be a decent one).