Nissan 370Z Forum - New Install AVH 4500

Page 8 of 9

« First

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Audio & Video (http://www.the370z.com/audio-video/)

- - New Install AVH 4500 (http://www.the370z.com/audio-video/65783-new-install-avh-4500-a.html)

cheshirecat

05-30-2013 01:13 PM

That looks like the AC control system busted open.

As far as the glare, I would suggest turning up the brightness and contrast quite a bit, as well as tilting the screen 3-4 "increments". Glare was unmanageable otherwise.

Cbtech

05-30-2013 04:05 PM

yeah i did all different angles :( nothing works for that glare

Infamous

05-30-2013 06:49 PM

My hu isn't turning on. I think I have everything wired correctly. I've installed hu's before, but none using aswc axxess. I'm befuddled. How many wires on the axxess get hooked up, 3? Ground, power and remote and plug in the 3.5mm?
http://farm6.staticflickr.com/5441/8...b9a2e8e8_b.jpg

Cbtech

05-31-2013 04:41 PM

I only use three wires and the 3.5mm when I hooked up the axis. But then again I can't get mine to switch sources or tracks.

sent via my wrist watch calculator

kenchan

05-31-2013 06:47 PM

im using a pac so dont know. mine works perfectly though.

cheshirecat

06-03-2013 02:53 PM

Quote:

Originally Posted by Infamous (Post 2340495)

Make sure you have a good ground. The bolt in the middle of the cubby up near the triple gauge worked fine for me.

3seventz

06-13-2013 06:47 PM

Antenna adapter blue wire

1 Attachment(s)

Hello new member here. I have been searching and haven't found a definite answer.

Is that blue wire from the antenna adapter ok to splice with the microbypass blue + blue/white wire from the radio harness ? if not where did you connect yours?

Thanks in advance.

Cbtech

06-14-2013 02:47 PM

Quote:

Originally Posted by 3seventz (Post 2362330)

Yes :tup:

cheshirecat

06-14-2013 03:18 PM

Quote:

Originally Posted by 3seventz (Post 2362330)

Hello new member here. I have been searching and haven't found a definite answer.
Is that blue wire from the antenna adapter ok to splice with the microbypass blue + blue/white wire from the radio harness ? if not where did you connect yours?
Thanks in advance.

Yup- the 350 and 370 have an antenna amplifier that needs power from that line. Splice away.

kenchan

07-19-2013 10:11 PM

Quote:

Originally Posted by Cbtech (Post 2339250)

Here is the glare from the direction that I'm sitting at.

Attachment 70084

sent via my wrist watch calculator

do you have a follow up pict comparo with your new kenwood? :)

Cbtech

07-19-2013 11:00 PM

Quote:

Originally Posted by kenchan (Post 2411391)

do you have a follow up pict comparo with your new kenwood? :)

It's MUCH better I'll have to get a pic tomorrow and post it up

Sent from my Palm Pilot circa 1997...

kenchan

07-19-2013 11:42 PM

yah, i still haven't encountered my 4500BT being that washed out. might be something to do with the top film that was used on your production lot or something, but sounds :tup: that you fixed your situation. :D

Cbtech

07-22-2013 07:51 PM

Quote:

Originally Posted by kenchan (Post 2411391)

do you have a follow up pict comparo with your new kenwood? :)

Here's the pic with the Kenwood

http://img.tapatalk.com/d/13/07/23/tugavane.jpg

Sent from my Palm Pilot circa 1997...

kenchan

07-23-2013 11:36 AM

that's definitely in improvement but your screen is tilted now...

Cbtech

07-23-2013 01:58 PM

1 Attachment(s)

Quote:

Originally Posted by kenchan (Post 2415147)

that's definitely in improvement but your screen is tilted now...

I edited the pic a little to show the Pioneer was tilted at the time too...

http://www.the370z.com/attachment.ph...1&d=1374605830

http://www.the370z.com/attachments/a...9890498278.jpg

All times are GMT -5. The time now is 12:48 PM.

Page 8 of 9

« First

Show 40 post(s) from this thread on one page