![]() |
Audio Problem w/ Big System
Help Guys,
I have a Pioneer Avic N2 (Flip out/ In Dash DVD) thats going bad (very important point here, the screen went black, amongst many other issues). I have 2 Alpine Type R 12s, 1 Mono block 600w amp for each sub, and 1 Four Channel Amp for the Type R 6.5s and 6x9s. This is whats going on. I was cruising into work, I've never had any issues with the stereo except for the Head unit, the stereo was not up that loud at all. My subs cut out, but sound was coming through the speakers. I was like WTF? I get into work, I checked the fuses in the distrobution blocks, to see no blown fuses. I then checked the subs to make sure I couldnt hear a scratching sound or smelled them for blown voice coils. Nothing. I then checked all the power/ ground connections going into all of the amps, nothing was loose. I drove into work today, still had no power to the subs, but I did notice that when I turned up the volume, minus the subs, the sound would cut out and make a cracking sound in all but 3 of the 4 speakers, and the volume would cut down to almost a whisper out of the driver's side front 6.5. What do you guys think? Is it possible the Headunit's RCA connections could go bad? Or the Headunit could be so close to death that its causing this issue? Maybe a loose connection somewhere? I've never had an issue with the system until now, and its been in several years now. Please guys, give me some insight. thanks. I'll be handing out eRep all day.:tup: |
Hook an I-pod up to each amp input via a mini to rca cable. This will tell you if its the amp or deck.
|
Quote:
|
Have you checked the amps themselves? Sometimes they have a built in fuse usually <20A. Maybe that popped on the subs so the Amps are not supplying power, but the signal is still getting to the subs which is why you still hear music from them?
|
Quote:
Whats even more weird is how I tun up the volume and the highs cut start to cut out, and go to a whisper into only the one driver's side 6.5. Its weird man. Im sending you eRep as well, thank you! |
Quote:
My guess is your HU did take a dump, and it sent a spike through the system. The amp fuse might have absorbed it, but in the end some still got to the 1 speaker that doesn't work right now... If your highs are cutting out, where do you have a bypass filter setup at? The HU or the Amp? That will help lead you to where your issue might be... |
The bypass filter for the highs is through the Amp, it sucks because the headunit screen is out, so I cant see and or manipulate anything on the deck settings, but what Im going to do is test everything with a multimeter.
It'd be pretty funny for me to pull the deck out, put a new one in, and the problem is resolved that quickly.. If it were that simply, but in all honesty, it could very well be that simple. |
As cpt said use a mini jack to rca and run the amp directly off that START at 0 if the volume is up to much you could damage the amp and or speakers.
Make sure the car is on when you test or else the amps will not be on. Also make sure no sub wires are touching each other even a small piece could be shorting out the amp. As for the head unit...ya you know my outlook on pioneer east. |
Quote:
Well, my situation got a whole lot worse, now I have no sound from the speakers, just the factory tweeters. (This is a Mitsubishi Eclipse, Not a Z, btw) |
Matt, Im sending you eRep as well.
|
So I broke out the multimeter today, this being the 2nd time I had the time to look at my system, I initially checked all the fuses, no blown fuses, I then checked the OHM loads on the subs, they checked out good, I checked the current on all 3 amps, the two batteries and the isolater, and they all where atleast 12.7 volts, I then pulled the deck out, most likely thats headed to the trash, and we'll go from there. I'll keep yall posted.
Thanks for the input guys! You guys RULE & KICK AZZ! |
Ok so today, I pulled the Avic-N2 completely out of my car. I should be buying a new headunit either today or tomorrow. I really believe and I'd be shocked if I replace the headunit, and it fixes the problem. I'll keep yall posted.
|
I bought a new CD player today, it should be here ont the 10th, its the Kenwood KDC-X995..:happydance:
|
Quote:
Quote:
Quote:
Quote:
Quote:
http://www.foodandtell.com/wp-conten...res-johnny.jpg |
Quote:
Ohh Matt, I love you, buddy! |
All times are GMT -5. The time now is 06:04 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2