My Custom Build: Focal, Stereo Integrity, Arc, Zapco, Alpine, etc!

simplicityins · 07-13-2011, 09:21 AM

Quote:

Originally Posted by BrandonT

I was just curious if it can cascade more than one LP/HP per channel. Looking at the manual it uses only the single LP/HP. I can use that in combination with the PEQ to get the shaping of the roll off I want, but was hoping it could be done "properly".

BTW do you know how Zapco defines the center frequency of the Shelf filter?

I am hardly a technical guy but i will try hehe, if you need to know more about the dsp6, prolly best to contact zapco direct

I am more or less just famaliar with how to use it to tune

each channel has the option of high pass, low pass and bandpass, with the bandpass filter, you define the LP and the HP frequencies and cascading the two produces the bandpass. if you are talking about cascading several LP and HP together on a single channel, then no, it cant do that though there is hardly any benefit in the car audio world for that ability and i dont think any single processor out there can do it

on the second question, you know thats a good point, i should check it out...i assumed that the "center" when on shelving option is the point where the shelving effect takes place...but i could be wrong...so i will confirm it

b

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stereo Build	Nitex	Audio & Video	4	04-24-2011 08:21 AM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM
My 6140, Focal, Image Dynamics, Alpine install	teejnut	Audio & Video	15	11-17-2009 01:50 PM
2010 370Z Custom build order	wheee!	Nissan 370Z General Discussions	5	09-04-2009 05:40 PM