2-way component system wiring with Joying Android HU

bigaudiofanat

Speaker output left and right usually white is left and grey is right set. Those wires will go from the head unit directly into their crossover input. Out from there goes to the woofer and tweeter

__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know
Direct email address reimermatt@gmail.com
Owner of: Dynamic Mobile Audio Follow me below
https://www.facebook.com/Dynamicmobileaudio/

bangity

Hello,

I just installed the POLK component 2 sets. The bass is very weak compared to factory? The tweeter however is quite clear. Is there any way I can adjust this without using an amp?

So I cut the wires from the Joying port and put into INPUT in the crossover, I kept the wires of the woofer in the door (just connect the +purple and -blue to the POLK woofer). Then wires from the crossover into the tweeter.

When I adjust the SUB setting in the HU, there is no changes. Only when I adjust the LOW.

BTW, I only changed the Driver side so far (out of time and it turned dark outside). I am testing the difference between the LEFT (POLK) driver side and RIGHT (factory) passenger side using the "DRIVER" and "FRONT" setting of the Joying HU.


Thank you.

bigaudiofanat

No you will need an amp for more bass. Also being that the android head unit isn't up to RMS quality specks it's probably not even putting out what an aftermarket head unit would normally produce. You did run new wires from the woofer directly to the crossover correct?

__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know
Direct email address reimermatt@gmail.com
Owner of: Dynamic Mobile Audio Follow me below
https://www.facebook.com/Dynamicmobileaudio/