So for those of you who have installed the SPC upper control arms, what setting did you start out with on the caster? IMO it would be 0 degrees but I just want to clarify that before I finish the install.
I am installing H&R springs and SPC front and rear camber arms. So far I have the front camber all the way out and the front caster at 0 degrees. I know I will need an alignment but if 0 is good then it will save time and money when I go to get it done.
Also, when you had your car aligned after installation were there any problems that the techs had doing the alignment?
Thanks in advance
