Juleous

And here is another what do you think about my build thread, sorry but here it goes fairly simple me thinks.

I have put some big thought into upgrading the blows system.

System will be based on a Kenwood DNX 7140, with the three scosche harness adapters, wire harness, antenna, steering wheel adptr. Kenwood CMOS 200 Camera. Plus Sirius Sat setup do I need the full kit or just a couple of pieces?

Zenclosure 2-10" with 2 Alpine SWR1043D Subs
Alpine SPX-17REF components upfront
Alpine PDX-5 Amp

I am going to do the install myself, I have done plenty in past cars and watching all the tutorials I have decided I will do it myself. Apart from the usual wire and interconnects should I change anything up or add anything.

The PDX-5 I will mount behind the drivers seat like Matt did, the Alpine looks great back there.

Matt should I bridge the 4 into 2 channels for the fronts, run the two subs at 2ohms on the mono channel? And then add some rear fill off the deck amp later if I want too?

Thanks for all your advice!

Edit: forgot about full dynamat treatment of course, looking forward to road noise reduction.