Good call

So, since I work 7 days a week for the majority of each month, we have a four day weekend every so often . Yesterday, I spent about five hours tearing the car apart. I took the driver side pillar finisher off and realigned it. Replaced the lock pillar (I had ordered a new one because I knew I would end up breaking the old one), and aligned the hood and fenders so that they were aligned in accordance with the service manual. Now that everything is aligned at the windshield and pillar finishers, things are still off where the bumper meets the hood. At first I thought that the hood alignment was to blame, but now I am thinking that the radiator core support is shifted towards the driver side. I ran out of time, since I had some errands to run, but will rip it apart this weekend and see if I can line everything up again. Its only off a 1/4 of an inch, but it is enough to annoy me.

On a side note I recieved my RJM clutch pedal. I'll try to install that this weekend as well. I have also started my wish list:

AEM intake
24 row oil cooler
HKS 3 inch exhaust (may pick up the one in the classifieds)
Fuji front bumper (partial carbon)
AMS sides and rear (partial carbon)

hope everyone is doing well and thanks for reading!

Good luck on your build!


-Raj

Thanks Raj!