View Single Post
Old 07-19-2023, 05:37 PM   #2 (permalink)
vtec to vvel
A True Z Fanatic
 
vtec to vvel's Avatar
 
Join Date: Feb 2015
Location: 813
Posts: 3,909
Drives: 13 Z
Rep Power: 502909
vtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond repute
Default

Quote:
Originally Posted by Spaghetti999 View Post
Went for a hard 25 miles, 15 minute drive the other day
Noticed my clutch fluid was in the middle before pulling out...ive seen the fluid drop a year ago, and no problems since...so thought not much of it

25 miles later I arrive at my first stoplight...clutch pedal immediately engages right off the floor and does not come all the way up. I pull over, see clutch fluid is below the minimum level now. uh oh...
I fill it, and drive home just fine. Once home, same problem. Fluid is FULL after 25 mile drive back, BUT the pedal engages immediately and does not come all the way up again....

I checked the next 2 days and nothings changed, fluid full still. Cars been parked 2 weeks now, and pedal is fine now, and fluid is too. Only moved around driveway, have yet to road test....

Fluid has not been changed in my 2 year 26k mile ownership....it's dark.
Tried bleeding the fluid as a potential fix, the rusted bleeder valve broke off

How should I proceed? Is this correct order?
1. Bleed lines to see if problem is fixed
2. Change CMC if step 1 fails
3. Drop the trans..... if all else fails


130k mile car, previous owner changed CSC around 90k-100k mile mark when it left him stranded
If you are losing fluid, this is most likely the CMC.

The pedal dropping and not returning is likely the CSC.

When the previous owner changed the CSC, do you know if it was OEM or the kit from Z1/ZSpeed?

A lot of members will recommend the ZSpeed kit over Z1. Sounds like you need to replace both the CSC/CMC, as any other solutions could be temp./band-aid solutions.
__________________
Don't like what I post? Too bad. I really don't give a sh!t
vtec to vvel is offline   Reply With Quote