Nissan 370Z Forum - View Single Post

Girald · 07-21-2020, 03:18 AM

EM-38 fo the FSM states that 22ft lbs is the torque spec (to tighten a nut and fasten an exhaust manifold to the rods fastened to the crank case).

------------------------------

EM 39 states that the tightening sequence is as follows:
( the sequence as i post it is relative to the picture)

Drivers side

<--- Front of car
3286
514 (you will go back and tighten "1" as the 7th step)

Passenger side
Front of car --->
6283
415 (you will go back and tighten "1" as the 7th step)

------

The bolt rods appear to be in the same order.

Torque specs for them on EM 38
11 ft lbs

07-21-2020, 03:18 AM	#7 (permalink)
Girald Base Member Join Date: Jun 2017 Location: Denver Posts: 134 Drives: 15' 370z SpTech 6MT Rep Power: 3362	EM-38 fo the FSM states that 22ft lbs is the torque spec (to tighten a nut and fasten an exhaust manifold to the rods fastened to the crank case). ------------------------------ EM 39 states that the tightening sequence is as follows: ( the sequence as i post it is relative to the picture) Drivers side <--- Front of car 3286 514 (you will go back and tighten "1" as the 7th step) Passenger side Front of car ---> 6283 415 (you will go back and tighten "1" as the 7th step) ------ The bolt rods appear to be in the same order. Torque specs for them on EM 38 11 ft lbs __________________ AAM tt'ed // Soon: Moving back to the East Coast Last edited by Girald; 08-02-2020 at 07:36 AM.