View Single Post
Old 12-23-2019, 02:03 AM   #10 (permalink)
Deqos
Base Member
 
Deqos's Avatar
 
Join Date: Dec 2015
Location: Dallas
Posts: 173
Drives: 14 Nissan 370z
Rep Power: 9
Deqos is on a distinguished road
Default

Quote:
Originally Posted by Rusty View Post
Found my notes. The 10mm was 40 ftlbs, and the 12 was 70 ftlbs. The heads have no markings on them to tell what they are. So I went with a spec in the middle. When you reassemble the halves. Take a honing stone with oil and stone the mating surfaces of each half. This will remove any high spots. The o-ring in between the halves. Make sure you put brake assemble lube or brake fluid on it before bolting the halves together.
I wish I could give you endless rep !! Thank you so so much rusty! Alright I’ll look up how to do all that and go buy the stone, I read on another thread that you said to use some blue liquid, I’ll find it again and use that to see the high and low spots.
Deqos is offline   Reply With Quote