Bumper FUBAR
Edit: I know this is more of a exterior/interior mods question, I'm asking here because it's specific to intercoolers and more specific to our application where literally half the intercooler is covered...
So, as some of you mat have seen, I decided to attempt to follow in the footsteps of ChaseZ and get some more airflow to all the heat exchangers. With that said, I may have totally failed and in doing so, completely mutilated my front bumper. I'm going to play with it some more, but I don't have a lot of faith in my ability to salvage it... What bumper would give the most airflow through the IC? Looking at some of our choices, I believe that the Stillen one is a good bet, but I wanted to pose the question to the collective experts. Thank you!
The picture of the cut bumper on the car is before I made the sides even with each other (the left cut is closer to the IC than it should be by 1/2 inch)
The picture off the car is how my bumper is sitting right now.
Last edited by turtle64b; 07-31-2017 at 01:32 PM.
Reason: Clarify
|