Hi guys,
I've been super busy as of late and finally have the chance to put all of my stuff up for sale.
I took these pictures a while back, and if needed to I can take more updated photos of stuff tomorrow
Local sales first then later I will contemplate shipping
I'm pretty firm on pricing, but I'll still be open to offers. Just don't low ball me.
Varis Carbon Hood: $1400
That's including a $300 clear coat job and no 4 month wait to have it made and shipped over. There is a tiny tiny little knick in the clear coat probably from a rock. I will take pictures of it tomorrow. I had this on for a little over 4 months and have receipts to show for it. I had to rent a U-haul to move this thing around so you'll have to come to me if you decide to buy it
Litespeed full titanium exhaust+y-pipe: 1800
Y-pie is pretty scratched up, but its fine. I had the exhaust fixed up about a year ago and the welds are holding strong. I had it done through a guy who was capable of working with titanium. Here's a few pics and its a pretty good job considering I've seen some pictures of a horribly fixed Amuse exhaust a while back. I can post more detailed pics if needed. Vid of throttle blipping is below
Berk HFC: ~ sold to CM370
Had these on for about 6k miles
BC BR coils + swift springs: ~sold to mike370
I probably had these on for about 9k miles left or right
SPL upper control arms: ~sold to BeemaaZ
Put on at the same time as the coils
SPL rear camber + toe bolts: $200
Put on at the same time as the coils
Swift Spec-R springs: ~sold to WigglyTurtle
These probably have around 6k miles. Took them off when I put the coils on just was too lazy to post these up for sale
Stillen CAI: ~sold to Iamdoch
Not sure how long they've been on
Tomei Y-Pipe still available
Tomei cat-back section ~ sold to 6mt370
Barely even used as you can see on the Y-pipe. I was able to fit this exhaust without any modification, but it hung pretty low. As a results it's scraped up at one point. Then somewhere down the line I ran over a paint can and it got covered in black s***. You can probably take it off with acetone, but I just never bothered to do it.
If I had to seperate the two items it would be: 500 for the y-pipe and 300 for the exhaust.
When I visited Tomei USA's office they said they sell replacement parts so you could go that route if cleaning it doesn't work.
Stillen 19 row thermostatic oil cooler: ~ Gone to abdulisraddd
Free you say? What's the catch?
Well, my lazy a** didn't clean it when I took it off a while back. So It's pretty dirty. Plus some other reasons not regarding the condition its in. If you wanna know why just pm me.
Again all sales are local first and then I'll contemplate shipping later. I don't have a mode of transporting the hood so you'll have to come to me to pick it up. All other items, I'm willing to meet up as long as its not too far from Irvine, CA.
Additional pics can be provided upon request.
I will try to answer all questions as best as possible.
Also, I will have a set of BC forged HB29 wheels going up for sale soon so keep an eye on that.
If there are grammatical or spelling errors, I apologize since this was done so hastily.