Nissan 370Z Forum - View Single Post - fLat bottomed (girls) make the race car go round!!!

synolimit · 02-03-2016, 05:14 PM

It's not done yet, all the self tapping screws will be replaced with rivets holding the fins on. Also going to paint it black with the tips of the fins painted red.

Also cut the fins back 5.5" as it was to low and now I have 2.75" clearance just like my front spitter.

There's a diff cooler under there with a cage I built thats bolted to the underside of the car at the same angle, there's 4 self tapping screws to that. Then I have 4 brackets with 1x1/8" plate holding the back end and sides up which is bolted to the rear crash bar and the side body of the car. Then I have a bunch of self tappers into the bumper and stuff holding it all down snug.

02-03-2016, 05:14 PM	#45 (permalink)
synolimit A True Z Fanatic Join Date: May 2013 Location: Columbus, OH Posts: 5,051 Drives: 2013 Silver 370z Rep Power: 3388	It's not done yet, all the self tapping screws will be replaced with rivets holding the fins on. Also going to paint it black with the tips of the fins painted red. Also cut the fins back 5.5" as it was to low and now I have 2.75" clearance just like my front spitter. There's a diff cooler under there with a cage I built thats bolted to the underside of the car at the same angle, there's 4 self tapping screws to that. Then I have 4 brackets with 1x1/8" plate holding the back end and sides up which is bolted to the rear crash bar and the side body of the car. Then I have a bunch of self tappers into the bumper and stuff holding it all down snug. __________________ 13 370z- Last edited by synolimit; 02-03-2016 at 05:18 PM.