Nissan 370Z Forum - View Single Post - [b]h.e.l.p.[/b]

diewithme · 01-18-2015, 05:45 PM

Hi guys,

I would strongly appreciate if someone could give me advice about my concern

shortly : My zed is 2014,EU, 7AT, regular version (not nismo), everything has been running well, until my car got some modes -F.I. catback 18inch (this is ok for sure) and Stillen CAI 3GEN. After installing CAI (all done by dealership), the salesman called me a I was told that engine cant keep idle revs - going up/down. When they returned the car to stock intake, everything was ok.
He tried to explain it to me, that the values on MAF sensors being very high due the increased diameter of intake tubes and the CPU was unable to deal with it/learn.

Than he told me, that tomorrow there will be a techniciac skilled in wires and he will modify the wires to deal with that problem. I asked him (salesman) what exactly they want to modify, he responed - connectors and pins to set the "correct" values or to bypass reading errors.. WTF?? Never heard about doing this...

Please, can anyone make a suggestion, what could be the problem?

omg double post

delete please

PS. sorry for my poor english

01-18-2015, 05:45 PM	#1 (permalink)
diewithme Base Member Join Date: Sep 2014 Location: Slovakia Posts: 10 Drives: 2014 Nissan 370z AT Rep Power: 10	[b]h.e.l.p.[/b] - issues after stillen cai gen3 install Hi guys, I would strongly appreciate if someone could give me advice about my concern shortly : My zed is 2014,EU, 7AT, regular version (not nismo), everything has been running well, until my car got some modes -F.I. catback 18inch (this is ok for sure) and Stillen CAI 3GEN. After installing CAI (all done by dealership), the salesman called me a I was told that engine cant keep idle revs - going up/down. When they returned the car to stock intake, everything was ok. He tried to explain it to me, that the values on MAF sensors being very high due the increased diameter of intake tubes and the CPU was unable to deal with it/learn. Than he told me, that tomorrow there will be a techniciac skilled in wires and he will modify the wires to deal with that problem. I asked him (salesman) what exactly they want to modify, he responed - connectors and pins to set the "correct" values or to bypass reading errors.. WTF?? Never heard about doing this... Please, can anyone make a suggestion, what could be the problem? omg double post delete please PS. sorry for my poor english Last edited by diewithme; 01-18-2015 at 05:49 PM.