I just put a new rear diff in, and did the bushing at the same time. I used to cut method on bushing, but I used an air hack saw. Cut like butter, and took maybe 30 mins to get out.
I also found a much easier way to install the new center bushing. Place it in the rear, and use the handle of a hammer and position the end over the hole of the bushing. Now rest the handle of the hammer on that black bar the is a few inches down. Pull toward you and it pops right in. I'll post a picture tomorrow so you can see what I'm talking about
__________________
2010 370Z Touring MT | Stillen | Motordyne | Momentum| Z1 | Fast Intentions | Advant Garde | RE11 | Swift | SPC | Quaife | Whiteline | Evo R | 322RWHP 259ft-lb Mustang
|