Nissan 370Z Forum - View Single Post

AzSpeng · 01-07-2014, 05:21 PM

alight folks! Its time!!! Going to turn this into a pretty neat product. Ill have video shortly..just finishing up the tool paths and whatnot.

Phunk, going to be using a mitsubishi 1" indexable endmill, 15krpm, .009" ipt, 270IPM at a .25" DOC and 1" WOC using high speed tool paths, through spindle coolant @ 1000psi...and a nice 22 degree ramp angle...should be nice and loud!.

01-07-2014, 05:21 PM	#198 (permalink)
AzSpeng Enthusiast Member Join Date: Nov 2013 Location: Chandler, Az Posts: 345 Drives: Skyline GTR Rep Power: 11	alight folks! Its time!!! Going to turn this into a pretty neat product. Ill have video shortly..just finishing up the tool paths and whatnot. Phunk, going to be using a mitsubishi 1" indexable endmill, 15krpm, .009" ipt, 270IPM at a .25" DOC and 1" WOC using high speed tool paths, through spindle coolant @ 1000psi...and a nice 22 degree ramp angle...should be nice and loud!. Last edited by AzSpeng; 01-07-2014 at 05:40 PM.