Quote:
Originally Posted by GaleForce
I might be in. I would like more details on the actual installation (chip set business) and pricing.
|
Sorry I was away for a few days. The installation of the chips is simple. You have to cut the signal wire of the abs sensor, splice in a single chip for each sensor. For the two fronts, you remove the splash shields and tap in right after the sensor. The rears are easy and are tapped in the trunk. Then a single wire is ran from the chips to another small board near the race logic. 4 inputs from the sensor, 4 outputs to the racelogic, and a ground.
The 4 small chips are around the size of a dime. The main chip is roughly the size of two quarters.
Let me know what else you would like to know. If this goes through, I will make it very hard to not install correctly. I have wire colors, pictures, ect... but I am not going to make a manual if there is no intrest.