Prep work is everything
3M general adhesive cleaner.
Safe for auto paint also Wipe everything .
Clay bar is must. If there is Anything on the paint. And I meant Anything , it pops out when it gets under vinyl.
Make sure clean your edges of car over and over .
Tools
Power Slam Magnets Q=12
Knife Tape Reel with 50' of 1/8" knifeless Finish Line Tape Q=1
Olfa stainless Art Knife Q=1
GeekWraps® Soft Edge Micro Detail Squeegee Q=1
China Marker Q=1
4 inch Soft Edge Super Squeegee
4 inch Soft Edge Marine Squeegee
6 inch Soft Edge Super Squeegee
6 inch Soft Edge Marine Squeegee
1.25 inch Detail Squeegee
1.25 inch Marine Detail Squeegee
Competitive Edge Squeegee
From geek wrap .
Heat gun
Try not to over heat the vinyl. Minimum heat and Minimum stretch would be best way to go. But it will take time to figure all that out.
uploadfromtaptalk1369021505871.jpg
You would never imagine how dirty your car is Until you clean it. doing Paint protection install requires a lot of cleaning and Its never good enough .
uploadfromtaptalk1369021666890.jpg
Cutting vinyl by door trims are very risky to touch the paint. Try to cut the vinyl on the trim. I can cut the vinyl on the paint with out touching the paint. That takes years of training. Over wrapped and tuck in is your best bet. Make sure use fresh blade every time