Here's a write up from our friends at
Adam's Australia:
Hello Ladies and Gentleman,
Some of you may have seen a recent post of mine regarding a hood/bonnet found at a local Wrecker.
The back story can be found here:
Adam's Polishes Results - Adam's Polishes Forums
Mook asked if I had taken pictures of the process and I did, so here they are.
Image 1- Bonnet as found with visible rust defects.
Image 2- Taped off and ready for a barrage of Adam's goodness
Image 3-
Car Wash Shampoo and
APC wash
Image 4- Post wash result and ready for
Detail Spray and Clay Combo
Image 5- New Clay kneaded
Image 6- Sister assisting in Claying. Oxidation and grit on Clay
Image 7- Clay close up
Image 8- Post Clay and ready for
Adam's 3 step Machine Polishing System with Gen4 Pads using PC 7424XP
Image 9-
Adam's Severe Swirl Remover 4 passes at 5000 opm
Image 10- Post Severe Swirl Remover passes
Image 11-
Adam's Swirl & Haze Remover 4 passes at 5000 opm 1 pass at 6000 opm
Image 12- Post Swirl & Haze Remover passes
Image 13-
Adam's 4" FOCUS Pads at work for stubborn scratches. Using Metabo Cordless Drill with 4" Drill Backing Plate
Image 14- Swirl and Haze with pea sized drops
Adam's Machine Super Sealant and
Brilliant Glaze were applied at the end. (forgot to take photos)
Image 15-20- Assorted Shots of finished result!
Thanks for looking!