This is the most confusing part of my install. Why is everyone installing 2 resistors when the instructions call for one? Did the instructions change again, or what am I missing? (The online instructions don't mention using a 47 ohm on the pink wire)
Here is what the instructions say:
"Note 179: Nissan08: Connect a 150 ohm resistor to pin 16 (Blue) in the vehicle connector. Connect the free ends of the resistors to the INTERFACE'S White wire. Connect pin 6 (Pink) in the vehicle connector to INTERFACE'S White wire. Connect pin 15 (Black) in the vehicle connector to Ground. This connector is the radio plug."
And they go on to say this, which isn't mentioned anywhere else in this post. I think it's bluetooth specific. I guess it has me just jump the pins together?
"Nissan32BT: Connect pin 12 to pin 17, connect pin 13 to pin 18, connect pin 14 to pin 19 (connector is viewed from pin side not wired side). Factory Bluetooth module is located in the trunk area."
|