Hmm ok just didn't think I would need to adjust camber for my size/offset

*crickets*

I want a look just like this.

I'm planning to get the following setup. Please help me verify if this fits on my Z with Swift Spring and APC rear camber

Front: 19x9.5 +25 (tire 245/40)
Rear: 19x10 +22 with 15mm spacer to make offset +7 (tire 275/35)

Please help me double check before I put in the order. Thanks.

Any one running?

245/40 r19/9.5
295/35 r19/11

275,85,95/35's getting pretty common on the front & 325,335,345/30's out back.

sorry guys...can't help, me too lazy. Try reading thru the first 10 pages of this long *** thread. I am sure these standard set ups have been covered times and times over.

Yeah I think the 11 wide is throwing me ran a 285/35 before and it looked too stretched. But I don't want any bulge at all and around 26.5-7 overall diameter.

I think the 265/305 is still the best bet

Will these fit:
Advan Gt gold
20x10.5+24
20x11+15
Also what size tire is recommended, dropped on swifts. Thanks

you are pushing it on the front unless you plan on stretching and/or some heavy camber. super flush for say a 265 is going to be in the +20 to +25 range. taking +20 on 9.5 as the mark. you are still 9mm more poke.

back will fit anything up to a 325 (just barely) on that offset. I am running 20x11 with 325/30r20 and 1.7*camber with no rubbing. 305 would fit beautifully.

Here you go:

19x9.5 +20 on 265/35
http://i1043.photobucket.com/albums/...sulugzbkq.jpeg

19x11 +15 with 5mm spacers and SPL camber links on 305/30
http://i1043.photobucket.com/albums/...shzweao73.jpeg

I tried 5mm spacers up front and there was very noticeable rubbing. No camber arms on the front. Tires are Bridgestone RE-11.

I agree with Antivenom, would be good if you could test fit a rear Nismo wheel (19x10.5+23) just 1mm further out...it will give you an idea.
I run very little negative camber, so A 10.5wheel would have to have around a +44 wheel & have 4" of front spacing.
Your rears are conservative compared to the front/ a +6 11"would be a more even poke.
All suspension setups are different & hard to know unless you have desired alignment & camber specs.

Camber plays such a Huge role, mine are 18x8+23 & 18x9+10 after spacers w/245/45 & 275/40'shttp://uploads.tapatalk-cdn.com/2016...e669ce8174.jpghttp://uploads.tapatalk-cdn.com/2016...dda5bf6d80.jpg




Sent from my iPhone using Tapatalk

Thanks!

What are your camber specs in this picture? Trying to figure out how much I'll need since I'll be running a 275/35 on a 19x10 +20.